| Command | Description | Supported | Comment |
| G00 | Move with shutter closed | Y | |
| G01 | Linear Interpolation | Y | |
| G02 G20,G21 |
Circular Interpolation (CW) | Y | Not clear if G20 and G21 recognized |
| G03 G30,G31 |
Circular Interpolation (CCW) | Y | Not sure if G30 and G31 supported |
| G04 | Ignore Block Data | Y | comment |
| G06 | Parabolic Interpolation | N | |
| G07 | Cubic Interpolation | N | |
| G10 | Linear Interpolation 10X | N | |
| G11 | Linear Interpolation 0.1X | N | |
| G12 | Linear Interpolation 0.01X | N | |
| G24 | Special Mirror Image | N | |
| G28 | Ignore Block Data. If no valid code appears in next block revert to G01 (area fill only) | N | |
| G36 | Turn on Area Fill | Y | |
| G37 | Turn off Area Fill | Y | |
| G52 | Plot Symbol Reference | N | |
| G53 | Plot Symbol Reference (90) | N | |
| G54 | Tool Select | Y | |
| G55 | Photo Expose Mode | N | |
| G56 | Plot Symbol Reference | N | |
| G57 | display Referenced Symbol on Console | N | |
| G58 | Plot and display referenced symbol | N | |
| G59 | Ignore Data Block | N | should be easy to add suppport for this. |
| G60 | Linear Interpolation 100X | N | |
| G62 | Programmable Mirror Image | N | |
| G70 | Inch Units | Y | potential conflicts with mass parameters (MOIN) and external aperture list setting. |
| G71 | MM Units | Y | potential conflicts with mass parameters (MOMM) and external aperture list setting. |
| G74 | Disable 360 Circular Interpolation | Y | |
| G75 | Enable 360 Circular Interpolation | Y | |
| G90 | Absolute Mode | Y | potential conflict with Mass parameters (FS) and external aperture settings. |
| G91 | Incremental Mode | Y | potential conflict with Mass parameters (FS) and external aperture settings. |
| G92 | Specify Work Origin | N |
| G-Codes | D-Codes | M-Codes | Mass Parameters | Extended Mass Parameters |